FIG-1
FIG-3
FIG-2
FIG-4
32
GEO:CS1
ELECTRONICS
USER INTERFACE PARAMETERS
FIG-1 - TRAINING PARAMETER
This simulates the ring cycle (in unloaded state)
using a BEEP on each trigger pull, so the user can
practice their trigger technique o the eld.
> ON: TRAINING mode enabled.
> OFF: TRAINING mode disabled.
> CANCEL: Editing is cancelled and unchanged.
FIG-2 - SHOT COUNT MENU
This menu controls the shot counter parameters.
FIG-3 - GAUGE PARAMETER
This toggles the visibility of the gauge graphic in
the shot counter on the run screen.
> ON: GAUGE graphic enabled.
> OFF: GAUGE graphic disabled.
> CANCEL: Editing is cancelled and unchanged.
FIG-4 - GAUGE MAX PARAMETER
This sets the number that the gauge counts down from every time the CS1 is red.
This parameter can be set between 100 and 2000 in increments of 10.
To Next Page
Loading...
