52
4.2.1.11 sys set link_info <on|off>
This command is used to report the link status of the ports. Once it is enabled, it will prompt the port
status on the console. Or if you disable it, it will not prompt the port status any more. The screen in
Figure 4-18 appears.
Figure 4-18: System link report setting Screen
4.2.1.12 s
ys aging <aging_time>
This command allows setting the aging time of SGSW-4802. The available range is 0-128(0=disable
aging time). The screen in Figure 4-19 appears.
Figure 4-19: Aging time setting Screen
To Next Page
Loading...
Need help?
General