58
4.2.3.5 port set enable <port number> [-h|-f] [-10|-100|-1000] [-A]
This command allows setting the speed duplex mode of each port. The screen in Figure 4-29 appears.
Figure 4-29: Ports set enable Screen
4.2.3.6 port set disable <port number>
This command allows disabling each port of SGSW-4802. The screen in Figure 4-30 appears.
Figure 4-30: Port set disable Screen
4.2.3.7 port set fl
w <port number> <on|off>
This command provide disable or enable flow control on each port of SGSW-4802. The screen in
Figure 4-31 appears.
Figure 4-31: Flow control disable /enable Screen
To Next Page
Loading...
