Planmeca Proline XC Panoramic X-ray 1
INTRODUCTION
User's manual
1 INTRODUCTION
The Planmeca Proline XC X-ray unit uses panoramic
and cephalometric techniques to produce X-ray
images for the diagnosis of dentomaxillofacial
anatomy. The unit is allowed to be used only under
supervision of a dental health care professional.
This manual describes how to operate the Planmeca
Proline XC Panoramic X-ray unit. Please read these
instructions thoroughly before using the unit.
Planmeca Proline XC panoramic X-ray fulfills the
requirements of Directive 93/42/EEC.
NOTE This manual is valid for software revisions: PK
6.54 or later and PG 6.52 or later.
CAUTION This X-ray unit may be dangerous to both
patient and operator unless safe exposure
values are used and correct operating proce-
dures are observed.
CAUTION Federal law restricts this device to sale by or
on the order of a dentist
.
All key illustrations indicate that the key should be
pressed or, where indicated, pressed and held down.
Pressing a key will either switch a function on or off,
depending on the original setting, or change the value.
The display values shown in this guide are only
examples and should not be interpreted as
recommended values unless otherwise stated.
The exposure values given in these instructions are
based on Kodak Ektavision green sensitive film and
Kodak Ektavision screens. If you are using a different
film and screen combination you may have to use
different exposure values.
The exposure values required to produce good X-ray
images will vary considerably according to the build
and age of the patient, the film processor used and
processing procedures being followed. Therefore, the
exposure values given in this guide are average
values and are only meant to guide the user. Users are
encouraged to develop their own radiographic
techniques based on these values.
To Next Page
Loading...
