Planmeca Proline XC Panoramic X-ray 3
WARNINGS AND PRECAUTIONS
User's manual
3 WARNINGS AND PRECAUTIONS
NOTE It is very important that the place where the
unit is to be used and the position from which
the user is to operate the unit are correctly
shielded. Since radiation safety requirements
vary from country to country and state to state
it is the responsibility of the user to ensure
that all local safety requirements are met.
NOTE If the x-ray unit has been stored at
temperatures under +10°C for more than a few
hours, time must be allowed for the unit to
reach room temperature before turning it on.
CAUTION This X-ray unit may be dangerous to both
patient and operator unless safe exposure
values are used and correct operating proce-
dures are observed.
NOTE The patient positioning lights are class II laser
products (21 CFR § 1040.10).
NOTE Class 1 laser product (Standard EN 60825-
1:1994).
The patient positioning lights are class 1,
inherently safe laser lights.
NOTE EMC requirements have to be considered, and
the equipment must be installed and put into
service according to the specific EMC
information provided in the accompanying
documents.
NOTE Portable and mobile RF communications
equipment can affect Planmeca Proline XC X-
ray unit.
CAUTION The remote exposure control, Autoprint and
Admark film marking systems are connected
to the X-ray units Planet connectors. Do NOT
connect any other devices to the Planet con-
nectors.
NOTE If a large number of exposures are taken in
rapid succession the X-ray tube may overheat
and stop working. A cooling time will appear
on the Main display which indicates the delay
before next exposure can be taken.
NOTE If the temperature of the tube head exceeds 60°
C the temperature will appear flashing on the
display. The unit will resume operation when
the temperature drops to the normal level. The
time will then reappear on the Main display.
NOTE Maintain audio and visual contact with the
patient and the unit during the exposure.
CAUTION
LASER RADIATION -
DO NOT STARE
INTO BEAM
1mW
635nm
CLASS II
LASER
PRODUCT
LBL-X-099
LBL-X-100
AVOID
EXPOSURE-
Laser radiation
is emitted from
this aperture.
To Next Page
Loading...
Need help?
General
