Planmeca ProOne 25
Installation Manual
INSTALLING THE DIGITAL SYSTEM
8.4 Installing the Dimaxis/Romexis imaging software
Install the software according to the instructions given in the software installation manual.
8.5 Installing the calibration files
Install the calibration files according to the instructions given in the software installation
manual, Appendix DIDAPI CONFIGURATION.
NOTE Use only the original calibration file CD-ROM supplied with the Planmeca ProOne X-
ray unit - you cannot perform the calibration without the original files. Leave the
original CD-ROM at the office where the X-ray unit is installed.
Printed copies of this document are considered uncontrolled.
7535.13.Rev001 08.07.2018
To Next Page
Loading...
