Planmeca ProOne Installation Manual

Planmeca ProOne 1
Installation Manual
INTRODUCTION
1 INTRODUCTION
This manual contains all the information required to install and calibrate the Planmeca
ProOne X-ray unit. Please read this manual carefully before installing the X-ray unit.
NOTE You will also need the Planmeca ProOne X-ray unit’s Technical manual (publication
number 10016258) during installation. The instructions for adjusting the X-ray unit
are given in the Technical manual.
NOTE This manual also explains the Ethernet link configuration procedure. The Dimaxis/
Romexis software packages have separate installation manuals. You will also need
the Dimaxis/Romexis software User’s manual.
NOTE Required software versions:
- Planmeca ProOne software version 1.0.0.r or later
and one of the following
- Planmeca Dimaxis software version 4.3.1.0.r or later
- Planmeca Romexis software version 1.6.0.0.r or later
Printed copies of this document are considered uncontrolled.
7535.13.Rev001 08.07.2018

Planmeca ProOne Specifications

General

Brand	Planmeca
Model	ProOne
Category	Medical Equipment
Language	English