22 P/N 2018 - 10 B Rev A 6 – Release
Notification Messages
Several notice messages may come up during acquisition.
To avoid unnecessary battery drain, the measurement beam will be turned off and
measurement canceled if an eye measurement is not acquired within three minutes
after entering into acquisition mode:
If no successful measurements were taken due to device tilting or non-alignment, the
following message may appear if you proceed to a new patient:
If you proceed to a new patient but only one of the eyes of the current patient have
been measured, the following screens will appear. Press to proceed anyway or
to return to the results screen.
To Next Page
Loading...