5P/N 2018 - 10 B Rev A 6 – Release
PlenOptika QuickSee
Basic Care
1. The QuickSee is a precision instrument. DO NOT drop or subject it to physical
shock. If device is dropped or suffer a physical shock functionality may be affect-
ed. To ensure proper functionality of the device after any non-negligible physical
shock the device needs to be inspected by PlenOptika.
2. The QuickSee is NOT waterproof. If you accidentally drop it into liquid or liquid
is spilled on the device, contact PlenOptika Support immediately. If minor water
droplets are found on the device, wipe off with a soft dry cloth.
3. DO NOT leave the QuickSee in excessive heat, such as in a car or in direct sun-
light. High temperatures can cause the device to malfunction.
4. The QuickSee contains precision electronic circuitry. NEVER attempt to disas-
semble the QuickSee or remove the battery; this may result in bodily harm and
will void any warranty.
5. DO NOT use cleaners that contain organic solvents to clean the QuickSee’s body,
LCD screen, eye lenses or back viewing lens.
6. Use a microfiber cloth for cleaning and for stubborn stains use with a small
amount of water or a non-abrasive cleaner. Always keep the back viewing lens
free of fingerprints, dirt, and dust.
7. When plugging the AC power connector into the QuickSee, DO NOT force the
power connector into the device as this may cause damage and will not be cov-
ered under warranty.
8. DO NOT store the QuickSee in its case with the power cord plugged in, this could
cause damage to both the power cord and the device. If plugged in, store in a
location with no interference with the power cord.
9. DO NOT swing the device on the lanyard to avoid unnecessary collisions and
incidental damage.
10. DO NOT push or scratch the touchscreen display surface with anything stiff or
rigid. A stylus is acceptable for use with the device if desired.
11. DO NOT spill liquids on the QuickSee. Please wipe off drops of liquid like saliva
and water on LCD panel surface immediately.
12. The device is NOT intended to be used in conjunction with any flammable gases
or liquids.
13. Electrically-powered medical devices connected to the electrical network in
which the QuickSee is connected should meet EMC standards.
14. The device is NOT intended to be used in intense electromagnetic environments,
check EMC specifications of the device in this document (immunity guidance
table).
To Next Page
Loading...