39P/N 2018 - 10 B Rev A 6 – Release
Environmental Protection
Electromagnetic Compatibility
The QuickSee conforms to the EMC standard (IEC 60601-1-2:2015).
• MEDICAL ELECTRICAL EQUIPMENT needs special precautions regarding EMC
and needs to be installed and put into service according to the EMC information
provided in the accompanying documents.
• Connectors should not be touched and connections should not be made to these
connectors unless ESD precautionary procedures are used.
• ESD protection mark may be used in lieu of protective covers.
• Portable and mobile RF communications equipment can affect medical electrical
equipment.
• The use of accessories and cables other than those supplied with the instrument
exception for cables sold by the manufacturer of the equipment as replacement
parts, may result in increase emission or decrease immunity of the equipment or
system.
• The equipment or system should not be used adjacent to or stacked with other
equipment. If adjacent or stacked use is necessary, the equipment or system
should be observed to verify normal operation in the configuration in which it will
be used.
• The emissions characteristics of this equipment make it suitable for use in indus-
trial areas and hospitals (CISPR 11 class A). If it is used in a residential environ-
ment (for which CISPR 11 class B is normally required) this equipment might not
offer adequate protection to radio-frequency communication services. The user
might need to take mitigation measures, such as relocating or re-orienting the
equipment.
To Next Page
Loading...