PRINCIPLE OF OPERATION
In Mode 1:
This mode is for booklets with approximately 6 to 11 sheets of paper that are being
Book folded.
When Infeed sensor SQF-Q5 is activated, the Transport belt Motor SQF-M1,
Solenoids SQF-SOL1-SQF-SOL4 and Stop gate motor SQF-M2 are energized,
moving the Stop gate upwards. Motor SQF-M2 runs until Stop gate sensor SQF-
Q1 becomes active, plus a certain amount of milliseconds. Motor SQF-M1 runs
until Clamp sensor SQF-Q6 is activated, plus a certain amount of milliseconds.
Solenoids SQF-SOL1-SOL4 deactivate immediately when Clamp sensor SQF-Q6
is activated.
When Transport belt motor SQF-M1 has stopped, Clamp motor SQF-M3 is
energized, moving the Clamps downwards. When Clamp motor Home position
sensor SQF-Q4 is activated / deactivated, Motor SQF-M3 is denergized. When
motor SQF-M3 is denergized, motor SQF-M2 is energized, moving the Stop gate
downwards. Motor SQF-M2 will run until sensor SQF-Q1 becomes deactivated.
Now the Clamps are holding the booklet, and Stop gate is down.
SQF-Q6 SQF-Q5
SQF-Q1
SQF-Q4
SQF-M3
SQF-M1
Set Clamp view,
seen from Outfeed view
Top view
Front view
Front view
SQF-SOL1&3SQF-SOL2&4
SQF-M2
To Next Page
Loading...