1
16
Undocking the Booklet Maker
Basics
First turn the Booklet Maker off, then turn the
Copier off.
Push in the latch on the docking assembly.
Move the Booklet Maker away from the Copier.
Note
Be careful not to damage the communication cable
Lift up the exit arm catcher and move the exit paper
arm to the lower position.
Take the shift tray from the shelf on the Booklet
Maker, and install it on the Finisher .
Turn the Copier on, the shift tray will now go up to
the upper position.
The Copier is now in standard Copier mode.
To Next Page
Loading...
