Advanced settings for
string modification
Enable to transmit predefined
barcode ID in Detail tab
Enter Prefix to be sent prior to
the decoded/received data.
Enter Suffix to be sent after the
decoded/received data
Translate designated text in the
Scan Data to another text
Delete designated length in
Scan data from the left
Delete designated length in
Scan data from the right
Bring designated length in Scan
data from the left
Bring designated length in Scan
data from the right
Select barcode types you want to read
There is “Enable All” and “Disable All” to enable/disable all symbologies
Specifies or enable
available detail settings
in symbologies
Tap/enable this checkbox to
enable the selected bar code
type.
Enter the desired features you
wish to transmit as bar code ID
Set the minimum and maximum
lengths from the pull-down lists.
If the numbers are the same,
acceptable bar codes will only
be that length. Not all types will
have this option enabled.
Redundancy(N560X
device only)
If you are encountering errors
when reading some bar codes,
you may want to adjust the
redundancy count. Redundancy
adjusts the number of times a
bar code is decoded before
transmission, which may reduce
the number of errors. Note that
the higher the redundancy
count, the longer it will take to
decode the bar code
Specifies Barcode engine type, Firmware revision, Decider revision, API revision
After modifying the current
settings, if you wish to return to
the factory defaults, tap the
Load Factory Default button.
To Next Page
Loading...
