Point Mobile PM450 - 4-Slot Battery Charger; Power Supply

68
Output (to the cradle)
DC 5V , 4A
Charging
Standard Charge
Main battery: Standard Capacity:3120mAh (450-BTSC) – Approx. 4hours
Extended Capacity : 5200mAh(450-BTEC) – Approx. 6hours
Status LED
Green: charged
Red: charging
Communication
Interface
MicroUSB connector supports data transmission of up to 480Mbps OR
Ethernet 10/100BASE-T(support only PM450-SEC)
Agency Approvals
Power Supply
UL listed
TUV licensed
Power Supply compliant to FCC part 15, Class B
Charging
CE Marking (EMC)
CISPR Pub 22
Fire Retardant
UL 94- HB
13. 4-Slot Battery Charger
☞NOTE: The 4-Slot Battery Charger is option accessory and needed to purchase separately with incidental expenses in
the aftermarket
13.1. Overview
The 4-Slot Battery Charger device is a four-slot charging station that should charge up to four Li-ion
battery Packs ( standard capacity 3120mAh : 450-BTSC, extended capacity 5200mAh : 450-
BTEC ) in four hours(3200mAh) and six hours(5200mAh). For more details about charging, see
Battery Charging on page 13-2.
13.2. Power Supply
The power cable that ships with each charger
WARNING: We recommend use of Pointmobile peripherals, power cables, and power adapters. Use of any
non-Pointmobile peripherals, cables, or power adapters may cause damage not covered by the warranty.
We recommend use of Pointmobile Li-Ion battery packs. Use of any non- Pointmobile battery may damage not
covered by warranty.
AVERTISSEMENT : Nous recommandons l'utilisation des périphériques, câbles d'alimentation et les adaptateurs
électriques fournis par Pointmobile. L'utilisation de tout autre périphérique, peut causer des dommages non
couverts par la garantie.
Nous recommandons l'utilisation de batteries Li-Ion approuvées par Pointmobile. L'utilisation de toute autre batterie
peut causer des dommages non couverts par la garantie
WARNING: DO NOT attempt to charge damp/wet handy terminals or batteries. All components must be dry
before connecting to an external power source.
AVERTISSEMENT : NE PAS tenter de recharger des terminaux ou des batteries encore humides ou mouillés.