5.21
ENGINE
5
29. Remove and plug the oil supply line going to the oil pump,
and route it through the guide (15).
30. Lift the front of the engine up and then tilt the rear so that
the engine straps clear the motor mount studs.
31. Carefully place the engine on top of the shock tower brace.
32. Remove the oil cable from the oil pump lever by holding
the pump open and rotating the cable and keeper to the slot
(16) in the pump arm.
33. Loosen up the lock nuts (17) and remove the cable from the
engine.
34. Remove the engine from the chassis.
15
16
17
To Next Page
Loading...
