7.10
FINAL DRIVE/BRAKES
DRIVE TRAIN
Jackshaft Exploded View
ITEM DESCRIPTION TORQUE SPECIFICATION / NOTES ITEM DESCRIPTION TORQUE SPECIFICATION / NOTES
A Chaincase 7.92, 8.37, 8.47 N Driven Clutch
BO-ring
8.37 chaincase - install seal sleeve (C) first,
then o-ring (B) on jackshaft
7.92 chaincase - install seal sleeve (C) first,
then o-ring (B) on jackshaft
O Washers Note the placement
C Seal P Flangette Nuts 11 ft-lb (15 N-m)
D Brake Disk Minimum thickness = .193" (4.9mm) Q
Driveshaft Flangette
Carriage Bolts
E Retaining Ring included on jackshaft R Nylock Nut 11 ft-lb (15 N-m)
F Jackshaft S
Speedo Pick Up (Speed
Sensor)
G Bulkhead area T Speed Sensor Bolt 5 ft-lb (7 N-m)
H Bearing U Speedo Pick Up Housing
I Flangette V Speedo Pick Up Gasket
JBelt W
Speedo Wheel Pick Up
and bolt
12-15 ft-lb (8.8-11 N-m)
K Spacer X Drive Shaft
7.92 chaincase - install o-ring (B) first then
seal sleeve (C) on driveshaft.
L Washers Y Chaincase Carriage Bolt
M
Driven clutch retaining
bolt
17 ft-lb (23 N-m) Z Nylock Nut 20 ft-lb (27 N-m)
A
B
D
C
E
F
AA
Q
P
O
N
M
L
K
J
I
H
G
X
W
V
U
T
S
R
Z
Y
To Next Page
Loading...
Need help?
General
