9.6
REAR SUSPENSION
SHOCK CONTROL RODS
Edge Shock Rods
Shock rods must be installed in the same orientation as set from the factory. Any changes made to the shock rod orientation other
than the factory setting may cause suspension damage.
The shock rods that are found on all 2007 Edge rear suspensions are shown below.
IQ Shock Rod
Below are examples of the IQ shock rod. The orientation of this rod is so that the plate is facing downward.
.63" (16 mm)
.45" (11.4 mm)
Lower
Upper
Trail RMK (lower end is smaller than the upper end)
340, 340 LX, 500 XC SP, SuperSport (both ends are the same size)
.475" (12 mm)
.475" (12 mm)
Facing Shock
Facing Shock
Shock Rod Assembly Example (Trail RMK Shown)
Shock
Lower
Upper
Plate facing down
(plate will look different
with suspensions utilizing
remote reservoir shocks)
To Next Page
Loading...
Need help?
General
