9.12
REAR SUSPENSION
Installing Heaviest Springs On A IQ 121" Suspension
Please reference the following information when installing heavy torsion springs (7043128/7043129) on sleds equipped with IQ 121"
suspensions. The issue that arises when installing the heavy spring is that the coil stack of the torsion spring is tall enough to interfere
with the suspension arm clamp nut. To work around this issue you will need to order two (one for each side) of the Parts below. You
will also need to relocate the two washers that are next to the clamp nut to the outside of the link arm.
Original Configuration
To Next Page
Loading...
