6.7
CLUTCHING
6
Non-ER LWT Driven Helixes
Team Helix Options with PERC
Team Ramp Angles
The Team helix is designated by the angle and length of the
angle on the back side of the ramp. The first number (A)
designates the starting angle of the ramp. The second number
(B) designates the finish angle. The last number (C) is the
transition distance (in inches) between the starting and finish
angles.
Non-ER LWT Driven Helixes
PART NUMBER DESCRIPTION
5135438 70/44 - .46 / 66/44 - .46
5135480 64/38 - .65 / 64/38 - .46
5135486 62/40 - .46 / 64/40 - .55
5135521 74/50 - .46 / 74/48 - .46
5135522 74/44 - .46 / 74/40 - .46
5135523 70/50 - .46 / 70/48 - .46
5135524 70/44 - .46 / 70/40 - .46
5135525 66/50 - .46 / 66/48 - .46
5135526 66/44 - .46 / 66/40 - .46
5135537 64/38 - .65
PART NUMBER DESCRIPTION
5133687 (58/44-46) ER
5133771 (58/42-46) ER
5133772 (62/46-46) ER
5133773 (62/42-46) ER
5133784 (58/40-46) ER
5133785 (62/40-46) ER
5133786 (62/44-46) ER
5133787 (62/48-46) ER
5133788 (60/44-46) ER
5133789 (60/46-46) ER
CAUTION
Do not install a non-ER helix on a Perc-equipped
snowmobile where the engine changes directions.
To Next Page
Loading...
Need help?
General
