10.10
CHASSIS & HOOD
6. Once all of the adhesive is removed from the decal area,
follow with a cleaning solution of 99% water to 1% mild
dishwasher detergent. Use a non-abrasive cloth with the
solution to remove dirt, grease, cleaning solvent, and finger
prints. Always clean the surface where the decal will be
applied.
DECAL INSTALLATION
All decals should be applied indoors, free from dust, dirt, cold
air, and humidity. Room temperature must be between 40_ and
100_F (4 - 38_C). These decals are to be applied dry.
1. Make sure the surface area of the hood where the decal is
to be placed is free of any dirt, debris, or adhesive.
2. Place the decal in the area to be installed and make sure that
everything lines up properly.
3. When you're ready to install the decal, carefully peel away
the adhesive side of the decal.
4. Apply the decal and slowly work the decal down the side
of the hood using a clean squeegee to lay the decal straight
and to avoid creating air bubbles. Do NOT remove the decal
mask until the decal is fully applied. If you attempt to use
a squeegee on the decal with the chrome exposed, the
chrome will be damaged.
5. When finished installing the decal, carefully remove the
decal mask at a 180_ angle.
6. Peel the backing off and install the urocals in the
appropriate places. These also have strong adhesives and
once applied they cannot be removed easily. Use a wall
paper roller to adhere all surfaces of the urocal. Urocal
decals are rigid and need to be rolled to ensure good
adhesion, particularly on the edges.
WARNING
IT IS EXTREMELY IMPORTANT TO REMOVE ALL TRACES OF
DIRT AND DEBRIS FROM THE HOOD WHERE THE DECAL IS TO
BE APPLIED. LEFT OVER DEBRIS WILL BE MAGNIFIED
THROUGH THE CHROME DECALS.
CAUTION
ONCE THE ADHESIVE STICKS, IT CAN BE VERY DIFFICULT TO
PULL THE DECAL BACK OFF OF THE HOOD. USE EXTREME
CARE! IF YOU ENCOUNTER AIR BUBBLES DO NOT ATTEMPT
TO USE A STRAIGHT PIN TO POKE THE BUBBLE AND LET THE
AIR OUT. A HOLE POKED IN A CHROME DECAL WILL BE VERY
NOTICEABLE.
To Next Page
Loading...
