6.13
CLUTCHING
6
Belt PN 3211115 Break -In Procedure
This is a new belt for 2007 and is used o the 600 RMK, Dragon
RMK and the Dragon IQ sleds. This belt can be used on any sled
that has a 11.5” (29.2cm) center to center distance or uses a
3211080 belt.
The manufacturing process of this belt requires a special break-
in procedure.
1. Clean the clutch sheaves with isopropyl alcohol.
2. Position the new belt so that the number of the belt face you
while you are standing on the clutch side of the machine.
3. Drive the unit for 20-50 miles and vary throttle speed
without exceeding half throttle and avoid aggressive
acceleration.
To Next Page
Loading...
