5.32
ENGINE
28. Lift engine out of chassis and carefully place engine on shock tower brace.
29. While holding the engine remove the throttle bodies by loosening up the intake boot clamps and separating the throttle bodies
from the intake boots.
30. Remove the cable located in the center of the throttle bodies.
31. Remove the oil cable lock nut from the threads on the cable housing.
32. Remove the throttle cable from the oil pump bracket.
33. Remove the oil cable (23) from the oil pump lever (24) by holding the pump open and rotating the cable and keeper to the slot
in the pump arm.
34. Remove the cable from the oil pump bracket.
35. Remove the engine from the chassis.
36. Inspect the motor mounts and replace if needed. See “Engine Mount Replacement” on page 5.5.
23
24
To Next Page
Loading...
