5.38
ENGINE
26. Install the front torque stop assembly and torque the plate
fasteners to specification.
27. Install the air box (13) onto the carb rack. Make sure to line
up the air box tabs with the air box plate (14).
28. Install the drive clutch. See “Drive Clutch Installation” on
page 6.20.
29. Install the driven clutch. See “Driven Clutch Installation”
on page 6.21.
30. Install the belt. See “Drive Belt Installation” on page 6.10.
31. Hook up the fuel filter and fuel return line by pushing them
together until you hear a audible “click”.
32. Secure the fuel return line “P” clamp (15) onto the side of
the airbox.
33. Place the fuel filter back into the holder (16) that is on the
airbox
34. Connect the ECU connection into the ECU.
35. Connect the EV solenoid connection to the EV solenoid.
36. Connect the coil connections to the coils.
NOTE: The WHITE connector (17) goes to the MAG
coil (upper). The BLUE connector (18) goes to the
PTO coil (lower).
37. Connect the regulator rectifier connections (19).
38. Connect intake air sensor (20) to the air box.
= T
Front Torque Stop Fasteners: 28 ft.lb (37.9 N-m)
14
13
15
16
18
17
19
20
To Next Page
Loading...
