8.12
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.
14. Install the intake plenum and throttle body assembly.
Place the intake plenum runners into the cylinder
head intake adapters.
NOTE
Be sure the intake plenum runners are fully seated in
the intake adapters before tightening the hose clamps.
15. Tighten the hose clamps to specification.
TORQUE
Intake Plenum Hose Clamps:35 in-lbs (4 Nm)
16. Install the fastener securing the bottom of the intake
plenum to the rear transmission mount. Torque
fastener to specification.
TORQUE
Lower Intake Plenum Fastener:22 ft-lbs (30 Nm)
17. Wipe any dirt off the fuel line connector and the fuel
rail. Reconnect the fuel line to the fuel rail.
NOTE
Be sure to tug on the fuel line after installing it to make
sure it is secured.
18. Connect the vehicle harness to the T-MAP sensor
(G), ETC (H), fuel injectors (J), rear differential relay
and rear differential solenoid (K).
19. Position the vehicle harness over the intake plenum
and install (5) new plastic tie straps to retain the
harness to the intake plenum.
20. Install the transmission shift cable and washer (L)
onto the bellcrank. Install the retaining clip (M).
TRANSMISSION
To Next Page
Loading...
