Polaris RZR XP4 1000 2016

3.28
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
19. Remove the six fasteners that attach the exhaust
head pipe to the engine. Remove the two exhaust
springs
i
that attach the head pipe
o
to the muffler.
Remove exhaust head pipe towards the front of the
vehicle. Discard exhaust gaskets
a
.
20. Remove the four fasteners retaining the box support
s
and the two fasteners retaining the box support
bracket
d
. Remove the push rivet that attaches the
heat shield
f
to the rear cross member.
21. Place a suitable drain pan under the vehicle and
remove the thermostat housing coolant hose
g
and
the water pump coolant hose
h
from the engine.
Dispose of engine coolant properly.
22. Use an overhead or portable engine hoist and
suitable engine straps to secure engine in its current
position.
23. Remove the four rear mounting bolts
j
that attach
the rear of the engine to the transmission.
NOTE
It is not necessary to remove the bolts that retain the
bracket
k
to the transmission.
ENGINE / COOLING SYSTEM