Poly Studio X72 - 5 System Setup; Set up Your System Using a Poly Touch Controller

System setup5
After connecting the peripherals, you can power on and set up your system.
You can set up the system using one of the following methods:
● Use the out of box setup on a Poly TC10 or Poly TC8 touch controller
The Poly TC10 or Poly TC8 must be on version 6.0 or later and connected to the same subnet as the Poly
Studio X72 system.
● Access the system web interface
● Onboard the system to Lens Cloud
Set up your system using a Poly touch controller
After connecting peripherals to your system, power on the system and complete the out of box set up on a
connected Poly TC10 or Poly TC8 touch controller.
The following instructions use a Poly TC10 to set up the system. You can use a Poly TC10 or Poly TC8 to out of
box your system.
To use a Poly TC10 or Poly TC8 to out of box your system, the Poly TC10 or Poly TC8 and your system should
be in an out of box state. If necessary, factory reset your Poly TC10 or Poly TC8 to return it to an out of box state.
IMPORTANT: Poly strongly recommends that you update your system to the latest supported Poly VideoOS
version for your system. Updating your system ensures that you have access to the latest system features and
functionality.
1. Connect the Poly TC10 to a PoE-enabled Ethernet port on the same subnet as the system.
The Poly TC10 powers on and displays the out of box screen.
2. Connect the Poly Studio X72 LAN port to the same subnet as the Poly Poly TC10.
3. Power on the system using the provided power adapter.
4. On the Poly Poly TC10, select Get Started.
5. Review the network and regional details, then select the right arrow.
6. Select Room Controller and select the right arrow.
The Poly Poly TC10 searches for the system in the out of box state and displays the results.
7. Use the system IP address to select your system from the results and select the right arrow.
Alternatively, select Manually Connect to a Room and enter the system IP address.
12
Chapter 5System setup