Handling a Mixture of Audio and Video Calls
When you are in a call with a person who has a video-enabled phone or video-conferencing system, the
participants' video displays on the connected monitor. For video calls with audio-only contacts, only your
video stream displays on the monitor, and an Audio icon displays on the monitor with the number of
contacts on audio.
When you do not have a camera connected to your paired content and video accessory (e.g., Poly Trio
Visual+ or Trio VisualPro), you can receive video but cannot send video. Video always displays when a
contact can send video and the system is enabled to receive video.
Camera Presets on Poly Trio Systems
You can store and modify camera presets on a Poly Trio system with a connected Poly camera.
Presets aren’t supported with the Logitech Webcam C930e camera.
Camera presets are stored camera positions that you can create before or during a call. Presets enable
you to quickly point a camera at pre-defined locations in a room and persist until you change them. The
system uses preset 0 as the default camera position for all preset camera positions. This default camera
position is zoomed out, panned straight ahead with horizontal tilt.
If your system camera supports pan, tilt, and zoom movement, you can create up to 10 preset camera
positions for the near-end camera. Each preset stores the following information:
▪ Camera number
▪ Camera zoom level
▪ Camera direction
▪ Snapshot of the camera view
Store Camera Presets
You can store camera presets during a call or when the Poly Trio system is idle with a connected Poly
camera.
Procedure
1. Do one of the following:
▪ During a call, select Camera .
▪ Select Menu and select Camera.
▪ On the Home screen, select Camera.
2. Adjust the camera to your desired position and zoom level.
3. Select Presets.
The available and stored preset positions display.
4. Press and hold a preset position numbered 0 to 9.
The new position displays immediately.
Video Calls on Poly Trio Systems
46
To Next Page
Loading...
