Introducing the Polycom HDX Systems
1 - 3
To power off the Polycom HDX system:
¾ Press and hold the power button on the remote control for 2 seconds.
¾ Press and hold the power switch on the front of the system for 2 seconds.
The following figure shows the location of the power switch and indicator
light.
The indicator light on the front of the system provides this information:
Indicator Light System Status
Off System is powered off
Steady green light System is initializing
System is awake and not in a call
Blinking green light (once) System received an IR signal while
awake and not in a call
Blinking green light (on 1 sec, off 2 sec) System is asleep, not in a call
Steady amber light System is in a call
Blinking amber light (once) System received an IR signal while in
a call
Blinking amber light System is in software update mode
System is in factory restore mode
Rapidly blinking amber light System is preparing to reset its
configuration
To Next Page
Loading...
