Networks
2 - 3
3. Select and configure these settings:
Domain Name Displays the domain name currently assigned to the system.
If the system does not automatically obtain a domain name,
enter one here.
Setting Description
Setting Description
DNS Servers Displays the DNS servers currently assigned to the system.
If the system does not automatically obtain a DNS server address,
enter up to four DNS servers here.
Changing this setting causes the system to restart.
Default
Gateway
Displays the gateway currently assigned to the system.
If the system does not automatically obtain a gateway IP address,
enter one here.
Changing this setting causes the system to restart.
Subnet Mask Displays the subnet mask currently assigned to the system.
If the system does not automatically obtain a subnet mask, enter
one here.
Changing this setting causes the system to restart.
LAN Speed Specify the LAN speed to use. Note that the speed you choose
must be supported by the switch.
Choose Auto to have the network switch negotiate the speed
automatically. Choosing Auto automatically sets Duplex Mode to
Auto. If you choose 10 Mbps, 100 Mbps, or 1000 Mbps you must
set Duplex Mode to Half or Full.
Note: Polycom does not support Auto for the Polycom HDX
system only or the switch only; the settings for both must be the
same.
Changing this setting causes the system to restart.
Duplex Mode Specify the duplex mode to use. Note that the Duplex mode you
choose must be supported by the switch.
Choose Auto to have the network switch negotiate the Duplex
mode automatically. Choosing Auto automatically sets LAN
Speed to Auto.
Note: Polycom does not support Auto for the Polycom HDX
system only or the switch only; the settings for both must be the
same.
Changing this setting causes the system to restart.
To Next Page
Loading...
Need help?
General
