Supported Polycom Video Systems
The Pano system can pair with the following Polycom video systems:
▪ Polycom
®
RealPresence
®
Group Series 310, 500, 550, and 700 systems with software version 6.0
or later.
▪ Polycom
®
RealPresence Centro
™
systems with software version 6.0 or later.
Connecting a Polycom Video System Using Two
Monitors
You can pair a Pano system with a Polycom video system using two monitors.
Note: In this scenario, the Pano system serves as an HDMI feed for the Polycom video system.
It
doesn’t receive content from the latter.
Direct Connection Setup
Y
ou can directly connect your Pano system to a Polycom video system using two monitors.
Remember the following about this setup:
▪ Monitor 1 shows near and far video.
▪ Monitor 2 shows near and far content (only if the Pano system is in a session).
▪ Annotations made to far content cannot be seen by far-end participants.
▪ Users can connect their device (such as a laptop) to the Pano system using HDMI to share content.
▪ Connecting the Pano system through any additional HDMI devices (such as a RealPresence Group
Series system or other codec) adds latency to the overall system.
▪ For the best touch monitor response time, connect the Pano system directly to the monitor.
The following diagram illustrates how the components for this setup are connected:
Integrating with a Polycom Video System
Polycom, Inc. 21
To Next Page
Loading...
