Figure 5: Room Setup with Three Monitors
Complete the Three-Monitor Setup
The following instructions describe how to connect your Pano system, Polycom video system, and three
monitors.
Procedure
1. Make sure the Pano system is running the latest software.
2. Set the HDMI splitter to Scaler.
3. Connect one end of an HDMI cable to the splitter.
4. Connect the other end of the HDMI cable to the HDMI Output port on the Pano system, shown in
the following figure:
Integrating with a Polycom Video System
Polycom, Inc. 29
To Next Page
Loading...
Need help?
General
