You may want to deploy Pano on a separate VLAN when you have both internal and guest users. The
internal users can connect through their normal connection (Wi-Fi or Ethernet) while guests or untrusted
users can connect using a different set of credentials with limited access rights. This deployment option
maintains your current setup and security and allows you to fine tune Pano’s network for added security.
Note: You can integrate Polycom RealPresence Group Series systems in this deployment. However,
you must allow outbound traffic from the Pano to the RealPresence Group Series systems.
Polycom recommends to only allow the ports required by Pano features.
Configure Your Firewall
You may need to work with your IT administrators to configure your firewall or network settings.
Procedure
» Configure your firewall or network settings in the following cases:
◦ To block any specific protocols
◦ To block Content App connections from Secondary network (untrusted network)
◦ To block management traffic
Port Usage
The Pano system uses a range of ports to handle communication with other systems, devices, and
network services.
Note: Your network must allow bidirectional communication between personal devices and the Pano
system.
System Deployment
Polycom, Inc. 35
To Next Page
Loading...
Need help?
General
