Related Links
Begin the HDMI Splitter Setup on page 23
Begin the HDMI USB Adapter Setup on page 25
Test Content Sharing on page 31
Connecting a Polycom Video System Using Three
Monitors
You can pair a Pano system with a Polycom video system using a three-monitor setup that lets you
display far video, far and near content, and Pano system content during a meeting.
Remember the following about this setup:
▪ The monitor that is connected to the Pano system must be touch-capable.
▪ You need three HDMI cables and a 4K HDMI splitter for this setup.
Polycom has tested and recommends an HDMI splitter by CSRET with the following specifications:
▪ 1x2 HDMI Splitter Amplifier version 2.0
▪ Certified for 4Kx2K (60Hz) and 3D 1080p
▪ Supports 1 in 2 out signal distribution
You can use a different 4K splitter. If you do, make sure the specifications are comparable to those of the
CSRET product.
Figure 4: Three-Monitor Setup
Note: In this scenario, the Pano system serves as an HTMI feed for the Polycom video system. It
doesn’t receive content from the latter.
Integrating with a Polycom Video System
Polycom, Inc. 28
To Next Page
Loading...
Need help?
General
