Entry Queues, Ad Hoc Conferences and SIP Factories
Polycom, Inc. 162
To enable ISDN (audio/video) participants to dial in to the Entry Queue, an ISDN (audio/video) dial-in
number must be assigned to the Entry Queue. Up to two dial-in numbers can be assigned to each Entry
Queue. The dial-in numbers must be allocated from the dial-in number range defined in the ISDN
(audio/video) Network Service. You can allocate the two dial-in numbers from the same ISDN (audio/video)
Network Service or from two different ISDN (audio/video) Network Services. The dial-in number must be
communicated to the ISDN-video or ISDN-voice dial-in participants.
The Entry Queue can also be used as part of the Gateway to DMA solution for connecting Audio only
ISDN-voice, ISDN-video, SIP and H.323 endpoints to DMA system.
For more information, see Gateway to Polycom® RealPresence Distributed Media Application™ (DMA™)
System.
Default Entry Queue properties
The system is shipped with a default Entry Queue whose properties are shown in the following table.
Default Entry Queue Properties
Parameter Value
Display Name DefaultEQ
The user can change the name if required.
Routing Name DefaultEQ
The default Routing Name cannot be changed.
ID 1000
Profile name • In HW MCUs - Factory_Video_Profile, with 384 Kbps Bit Rate.
• In VE MCUs - Factory_Mixd_CP_SVC_Video_Profile, with 1920Kbps Bit Rate
Entry Queue Service Entry Queue IVR Service. This is default Entry Queue IVR Service shipped with the
system and includes default voice messages and prompts in English.
Ad Hoc Enabled
Cascade None (Disabled)
Enable ISDN
(audio/video) Access
Disabled. You can modify the properties of this Entry Queue to enable ISDN
(audio/video) participants to dial-in to a conference. Up to two dial-in numbers can be
assigned.
To Next Page
Loading...
