Polycom realpresence 1800 - Getting Started; Install RMX Manager; Connect to the MCU with RMX Manager

Polycom, Inc. 15
Getting Started
This section describes the tasks that you may need to complete (based on your system design and
installation) to configure the Polycom RealPresence Collaboration Server after first-time setup.
Install RMX Manager
The RealPresence Collaboration Server can be managed and monitored with either the RMX Manager
application on a Windows-based system or the RMX Web Client application using Internet Explorer. For the
most part, Polycom recommends using RMX Manager to configure and manage the RealPresence
Collaboration Server. However, use the RMX Web Client when direct access to a single RealPresence
Collaboration Server, Appliance Edition is required.
To install RMX Manager:
1 Access Polycom Support at support.polycom.com. Polycom recommends using Microsoft Internet
Explorer for the download.
You can also install RMX Manager from the RMX Web Client login page.
2 In the Documents and Downloads section, select UC Infrastructure as the Product Type, your
model of the RealPresence Collaboration Server as the Product, and click Go.
3 Select the appropriate version of the Local Web Client (RMX Manager).
4 When prompted, accept the End User License Agreement and the Export Restrictions
Agreement.
5 When prompted, click Open and navigate to the
RMX_x-x-x-nnnn_LocalWebClient-RMXManager >
RmxManagerInstallerMsi
folder.
6 Double-click
setup.exe to install RMX Manager.
7 Follow the directions for the install wizard.
Connect to the MCU with RMX Manager
With RMX Manager, you can connect to one or more RealPresence Collaboration Server MCUs installed
on the network.The connection process has two steps: you first add the MCU, then you connect to the MCU.
Note the following about connecting RMX Manager to an MCU:
● The first MCU connected to RMX Manager provides the authorization level of users that can connect
to the other MCUs on the list.
● Each user can have a different login name and password for each of the listed MCUs.
● You must define all users in the user list of each of the listed MCUs.