Polycom, Inc. 174
System Flags
In general, configure the RealPresence Collaboration Server using the user interface. However, if
necessary, you can also configure the MCU for specific application and operational needs by adding
RealPresence Collaboration Server system flags and setting them to the required values. While many of the
predefined system flags have corresponding user interface settings, some do not.
Managing System Flags
The following procedures describe how to add, edit, and delete system flags.
Add a System Flag
Add system flags to the RealPresence Collaboration Server.
To add a flag:
1 In RMX Manager, go to Setup > System Configuration > System Configuration.
2 In the MCMS_PARAMETERS_USER
tab, click New Flag.
3 Enter a value in the New Flag and Value field, and click OK.
4 Click OK to close the New Flag dialog box.
The new flag gets added to the flags list.
5 Click OK to close the System Flags dialog box.
Edit a System Flag
You can modify the value of system flags from their default settings.
To edit a system flag:
1 In RMX Manager, go to Setup > System Configuration > System Configuration.
2 In the MCMS_PARAMETERS_USER
tab, select the flag to be modified and click Edit Flag.
3 Enter the value in the New Value field and click OK.
4 Repeat steps 2 and 3 to modify any additional flags.
5 Click Close.
To Next Page
Loading...
