EasyManua.ls Logo

Polycom realpresence 1800 - Add a New Conference Template

Polycom realpresence 1800
449 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Conference Profiles and Templates
Polycom, Inc. 36
Add a New Conference Template
Create conference templates to start and replicate successful conferences. Conference templates:
Identify the desired conference profile (and thus, parameters) for a conference
Identify that participants and participant parameters (including their personal layout and video forcing
settings) for a conference
Simplify the setup of telepresence conferences, where precise participant layout and video forcing
settings are crucial.
To add a new conference template:
1 In RMX Manager, click Conference Templates.
2 Click New Conference Template ( ).
3 In the General tab:
a In the Display Name field, enter the new template name.
b Specify the duration of the conference in hours and minutes and enable Permanent Conference
to create a standard recurring conference.
c Assign a Routing Name and ID or allow the system to assign them automatically.
d Select the required Profile.
e As required, assign a Conference Password that users must enter to join the conference or a
Chairperson Password that the chairperson must enter to take on the chairperson
responsibilities.
4 Go to the Participants section and:
a Click Add from Address Book, select the required groups and participants, and click Add
or
b Click New and enter the required information for the new participant, and click Add.
5 To assign a lecturer for Lecture Mode conferences, select a Lecturer from the participant’s list, and
if required enable Dial Out Manually so the MCU can initiate the dial out.
Dial-out and dial-in participants are two separate participants even if they have the same IP
address/number; therefore, if a dial-out participant is added to the conference, but that participant
dials in before the MCU dials out to him, the MCU creates a second participant in the Participants
list and still attempts to dial out to the participant. If the dial-out participant was designated as the
conference lecturer, the MCU cannot replace that participant with the dial-in participant that is
connected to the conference.

Table of Contents

Other manuals for Polycom realpresence 1800

Related product manuals