Appendix - Polycom Lab Features
Polycom, Inc. 330
To find out more about this Polycom Lab feature or provide feedback on this feature, contact Polycom
Support.
Description of Feature
When connecting a conference running on Polycom RealPresence Collaboration Server via an Entry
Queue, a still slide is used, which up until version 8.7 could be replaced by a different still slide.
From version 8.7.1, provided Polycom Lab features are enabled, and the motion slides feature is activated,
Polycom allows:
● Using a motion slide (video clip) instead of a still slide.
● Replacing the default motion slide Polycom supplies (within both installation and upgrade packages),
which is named General_Polycom_Slide_Motion, with a different video slide.
● Receiving motion slides from the DMA for external IVRs.
Video Slides Guidelines
● Since TIP endpoints are sometimes prone to encountering problems with customizing IVR slides, it
is possible to block video slides for TIP endpoints via the ENABLE_MOTION_SLIDE_TO_TIP_EPS
system flag (see below), in which case these endpoints cannot view video clips.
● Video clips size is limited to 5M to prevent memory overflow. Thus, up to 10 motion slides per a local
IVR may be loaded by the Administrator user.
● Bit rates are preset as described in the table below.
Release Feature is Being Tested In: Polycom® RealPresence® Collaboration Server, V8.7.1
Level of Testing Performed To Date:
None
Feature Unit Tested
Feature Unit and Product Regression Tested
Full Feature Unit, Product Regression, and Solution Tested
Note: Audio Prompt for Video Slide
The audio prompt to the video slide is taken from the IVR associated with it.
Bit Rate values per Resolution
Resolution Frame Rate Preset Bit Rate (Kbps)
CIF 30 384
SD 30 768
HD720 30 1024
HD1080 30 2048
To Next Page
Loading...
