Appendix - Polycom Open Collaboration Network (POCN)
Polycom, Inc. 404
TIP Layout Support & Resource Usage
Cisco Telepresence endpoints using TIP protocol support only one (CTS 1000) or three (CTS 3000) display
screens. Therefore, Polycom Telepresence endpoints will adjust their display to use one or three screens
as follows:
● OTX system - Works with three screens, therefore no adjustment is required and it should be set to
work in room switch Telepresence Layout Mode (while avoiding zooming in/out)
● RPX 2xx - This endpoint works with two screens, therefore it will adjust to use only one screen.
● RPX 4xx - This endpoint works with four screens, therefore it will adjust to use only three screens.
● Standalone HDX - behaves as the CTS 1000 and uses only one screen.
Collaboration
Server
8.1.1 and up MCU:
• Functions as the network bridge for multipoint calls between H.323, SIP
and TIP endpoints.
• The Collaboration Server can be interfaced to CUCM using a SIP trunk,
enabling CTS to join multipoint calls on Collaboration Server. Signaling
goes through the CUCM while the media in TIP format goes directly
between the CTS and Collaboration Server.
• The Collaboration Server must be configured to route outbound SIP calls
to DMA.
• Collaboration Server must be configured to send and receive RTP
streams to and from the Service Provider's SBC.
MLA Server 3.0.5 Multipoint Layout Application
Required for managing multi-screen endpoint layouts for Cisco CTS 3XXX,
Polycom TPX, RPX or OTX systems.
HDX and ITP
Endpoints
3.1.1.1 Telepresence, desktop and room systems.
• Polycom SIP endpoints must register to DMA as SIP Proxy.
Microsoft
Lync 2010 4.0.7577.183
CU4
Lync 2010 client 4.0.7577.405
1 CU4
Exchange 2007
R2 SP3
8.3.213.1
Exchange 2010
SP2
14.2.247.5
Outlook 2007 12.0.6557.50
01 SP2
Outlook 2010 14.0.6112.50
00
Solution Architecture Components
Component Version Description
To Next Page
Loading...
