Polycom SoundStation2 - Call Conferencing and Bridging; Adding a Call to Conference; Bridge Soft Key Setup

SoundStation2 User Guide - 15
Adding a call
1. While on an active call, press the
Conference button . The rst
call is automatically placed on
hold.
2. Dial the number you wish to call.
You may use the Redial or Direct
Dial method.
3. Press the Conference button
or JOIN soft key to join the second
call. To drop the second call,
press the Conf key again.
OR
Programming the Bridge number
1. Press the HOLDsoft key to place
the rst call on hold.
2. Press the Conference button
and enter the number you wish to
call. You may use the Redial or
Direct Dial method.
Bridge Soft Key
You may program the telephone number of
your preferred audio conferencing bridge or
service into the SoundStation2 so that it is
immediately available.
1. Press the Menu button ,
choose Bridge Setup using the
Scrolling buttons, and press
the Select button .
2. Choose Enter Phone Number and
press the Select button and
then enter the bridge number using
the dial pad. Enter any necessary
prex such as 9 and/or 1.
► If you make a mistake entering the
number, use the < DEL soft key to
correct the error.
3. Press the SAVE soft key or CANCEL
soft key if you wish to cancel the
procedure.
The SPEEDDIAL soft key will not
display when the bridge number
is congured.