Polycom SoundStation2 - Restore Defaults

SoundStation2 Administrator Guide - 30
►White Noise is a signal
whose energy is distributed
uniformly among all frequen-
cies within a band of interest,
which for the SoundStation2
is approximately from 300 to
3,400 Hertz.
3. Press the Select button to acti-
vate the signal.
Restore Defaults
Restoring the defaults will irretrievably remove all
settings and data that have been entered since the
SoundStation2 was rst installed.
1. Press the Menu button ,
choose Admin Setup and press
the Select button , enter
passcode (if required) and press
the ENTER soft key. Choose
Diagnostics using the Scroll-
ing buttons , and press the
Select button .
2. Choose Restore Defaults using
the Scrolling buttons , and
press the Select button .
Press the OK soft key if you wish
to restore defaults or the CANCEL
soft key or the Exit button
to return to the Diagnostics
submenu.
►Phone Book entries and Speed
Dial numbers are not lost when
restoring all defaults.