14-92 PN-0908073 Rev. 11
PS 164-2
THE ART OF WELDING
3. 3. 2. The remote control pendant
This allows:
• The positioning of welding heads and wire feed
units
• The starting and stopping of weld cycles
• The selection of the program to be executed
• The simulation of a cycle without welding
• Modifi cations to be made during a cycle
• The shielding gas to be tested
• The manual start of the cooling pump
• The stopping of a cycle in the case of an emer-
gency
Fig. 3.9 - Remote control pendant
To Next Page
