Polysoude PS 164-2 - Table of Illustrations

PN-0908073 Rev. 11 87-92
PS 164-2
THE ART OF WELDING
Table of illustrations
Fig. 3.1 - PS 164-2 ........................................................................................................... 10
Fig. 3.3 - MU IV welding head ............................................................................................ 11
Fig. 3.3 - PS 406-2 ........................................................................................................... 10
Fig. 3.4 - MW welding head ................................................................................................ 11
Fig. 3.5 - UHP welding head ............................................................................................... 11
Fig.3.6 - TS welding head ................................................................................................. 12
Fig. 3.7 - Polyfi l wire feeder ............................................................................................... 12
Fig. 3.8 - Description of power source PS 164-2 .................................................................... 13
Fig. 3.9 - Remote control pendant ....................................................................................... 14
Fig. 4.1 - Accessories of the PS 164-2 power source .............................................................. 16
Fig. 4.2 - Name plate of the PS 164-2 power source .............................................................. 17
Fig. 4.3 - Gas connections at the right side of the PS 164-2 .................................................... 18
Fig. 4.4 - Diagram to use only one gas ................................................................................ 18
Fig. 4.5 - Diagram to use two different gas .......................................................................... 18
Fig. 4.6 - Connection of the remote control pendant with the PS 164-2 .................................... 19
Fig. 4.7 - Connection of an MU welding head or a TP/TS welding head ..................................... 19
Fig. 4.8 - Connection of an air cooled closed chamber welding head ........................................ 20
Fig. 4.9 - Connection of a liquid cooled closed chamber welding head ( ---- for heads with
integrated commands) .............................................................................................. 20
Fig. 4.10 - Connection of a wire feeder ............................................................................... 21
Fig. 4.11 - Connection of a manual torch ............................................................................ 21
Fig. 4.12 - Front panel ...................................................................................................... 22
Fig. 4.13 - Back panel ....................................................................................................... 22
Fig. 4.14 - Synopsis .......................................................................................................... 23
Fig. 4.15 - The remote control pendant ............................................................................... 24
Fig. 5.1 - Buttons for manual rotation of the welding head on the remote control pendant .......... 25
Fig. 5.2 - Buttons for wire positioning on the remote control pendant ...................................... 25