Polysoude PS 164-2

To Next Page

To Previous Page

88-92 PN-0908073 Rev. 11

PS 164-2

THE ART OF WELDING

Fig. 5.3 - Gas test button .................................................................................................. 25

Fig. 5.4 - Push button "cooling circuit" - Start pump "cooling circuit" ....................................... 26

Fig. 5.5 - Port for memo card ............................................................................................. 50

Fig. 5.6 - "Set up / weld" selector switch ............................................................................. 54

Fig. 5.7 - "Start cycle" button ............................................................................................. 54

Fig. 5.8 - "Delta" buttons for modiﬁ cations of parameter values .............................................. 54

Fig. 5.9 - Example of a weld cycle report with manual downslope, denoted by error code

>>>> ! 52 ! <<< ................................................................................................... 55

Fig. 5.10 - Example of a weld cycle report with a normal cycle end, denoted by

>>>> ! OK ! <<<< .................................................................................................. 55

Fig. 5.11 - Printer switch ................................................................................................... 55

Fig. 5.12 - Manual downslope button ................................................................................... 56

Fig. 5.13 - Immediate manual stop button ........................................................................... 56

Fig. 5.14 - Emergency stop button ..................................................................................... 56

Fig. 6.1 - Inverter switch S3/2 for shunt circuit security system of monitoring welding current

in "CLOSED" position for adjustments (21700633 sequencer card) .................................. 58

Fig. 6.2 - Inverter switch S1/4 in " CLOSED " position (21700634 synoptic card) ....................... 58

Fig. 6.3 - Potentiometers and test points for the regulation of the current reference on the

21700633 sequencer card .......................................................................................... 59

Fig. 6.4 - Potentiometers for the regulation of the current and the voltage measurement (in-

terface card 2021700750).......................................................................................... 60

Fig. 6.5 - Adjusting the contrast and brightness of the display (synoptic card 21700634) ........... 63

Fig. 6.6 - Coolant inlet ...................................................................................................... 64

Fig. 6.7 - Change of paper roll ............................................................................................ 64

Fig. 6.8 - Change of ribbon cartridge ................................................................................... 64

Fig. 6.9 - Location of the fuse on the DC power supply +5 V ................................................... 65

Fig. 6.10 - Fuse bank ........................................................................................................ 65

Fig. 6.11 - Location of the ﬁ lter of the cooling circuit ............................................................. 65

Fig. 6.12 - View left side .................................................................................................... 71

Fig. 6.13 - View right side .................................................................................................. 71

Fig. 6.14 - Topview ........................................................................................................... 72

Polysoude PS 164-2 - Page 88