80-92 PN-0908073 Rev. 11
PS 164-2
THE ART OF WELDING
7. 2. Error codes
Number Origin Fault Consequence
10 Gas Lack of gas Immediate stop
11 Coolant Coolant circuit n°1 failure Forced downslope
20 Current Main voltage fault Cycle blocked
22 Current No ignition Immediate stop
23 Current Loss of arc Immediate stop
24 Current Short circuit electrode workpiece Immediate stop
27 Current Over heating Immediate stop
29 Current Source regulation fault Immediate stop
30 Rotation Rotation speed regulation fault Immediate stop
31 Rotation Rotation motor blocked Immediate stop
32 Rotation Rotation pulse emitter fault Immediate stop
40 Wire Wirefeeder speed regulation fault Forced downslope
41 Wire Wirefeeder motor blocked Immediate stop
42 Wire Wirefeeder pulse emitter fault Immediate stop
51 Sequencer Manual downslope Forced downslope
52 Sequencer Manual stop Immediate stop
53 Sequencer Processor reset Reboot
54 Sequencer Start position fault Immediate stop
56 Sequencer I2C bus fault Immediate stop
60 Printer Printer fault No printout
61 Printer Program absent No printout
62 Printer No corresponding data No printout
70 Saving Memo card absent No saving
71 Saving Error during saving No saving
72 Saving Program damaged No saving
73 Loading Card empty No loading
74 Loading Loading fault No loading
75 Loading Max. or min. current of the source
exceeded
Wrong selection of current range
No loading
77 Saving Card full No saving
To Next Page
Loading...
