58-92 PN-0908073 Rev. 11
PS 164-2
THE ART OF WELDING
PUSH
10 mm
min.
max.
60 mm
6. 2. Coolant
Please make sure that the coolant level in the res-
ervoir of the power source is always maintained. We
advise you to change the coolant once a year. Pump
out the used liquid by connecting a hose to the cool-
ant outlet (symbol
) and press the button BT 15
(symbol
)on the remote control pendant. Pure,
clean water should be used for rinsing the cooling
circuit. The refi lling of the coolant reservoir (about
2 l) is made by the top of the power source.
NOTE : Only use coolant recommended by Polysoude.
The use of any other coolant will void any warranty
commitment.
Fig. 6.1 - Coolant inlet
6. 3. Printer
6. 3. 1. Loading paper to the printer
The paper has to be loaded with the power source
turned on. To change the paper roll, you have to
open the cover (unscrew the 2 screws). Take out the
empty roll and insert the end of the new paper roll
into the printer. The paper advances by pushing the
printer switch SY 29 downwards. Insert the paper
into the slot of the cover before closing it.
Fig. 6.2 - Change of paper roll
6. 3. 2. Change of ribbon
To change the ribbon in the printer, you have to open
the cover (unscrew the 2 screws). The ribbon is situ-
ated below the printer block. Press on "PUSH" to take
it out. To insert a new ribbon, push it slightly to the
top when inserting it. Insert the paper into the slot of
the cover before closing it.
Fig. 6.3 - Change of ribbon cartridge
To Next Page
Loading...
