Polysoude PS 164-2 - Page 46

46-92 PN-0908073 Rev. 11
PS 164-2
THE ART OF WELDING
01 - NANT ES
S1 V32=200
S2 V32=180
S3 V32=180
01-NANTES N=0100 D
S1 V32=200
S2 V32=180
S3 V32=180
01-NANTES N=0100 D
S1 V32=200
S2 V32=180
S3 V32=180
01-NANTES N=0130 D
S1 V32=200
S2 V32=180
S3 V32=180
01-NANTES N=0130 D
S1 V32=200
S2 V32=180
S3 V32=180
20
5. 3. 5. 2. Modifi cation of sector start position
During modifi cation, the value of parameter "N" must
be between the values of the preceeding and the fol-
lowing sector. If this is not the case, the value will
not be accepted.