Operation
At outdoor temperatures below 0°C, let the machine idle for approximately five minutes
to allow the hydraulic system to reach the correct operating temperature (the hydraulic pipes
will then be warm to the touch).
"Autospeed"
"Autospeed" enables pressure-controlled switching between the two feed speeds.
▪ "Autospeed" responds to the required splitting pressure and automatically adjusts the
splitting speed.
The advantages:
Automatic pressure-controlled switching between the two feed speeds gives a faster
working speed.
▪ This in turn leads to a 30% increase in splitting performance.
The smooth, gentle switchover ensures the minimum of hydraulic wear.
Position "0"
Control levers in home position, pusher does not move.
Position "I"
When both control levers are simultaneously placed in position "I", the pusher is extended.
▪ The splitting speed is matched to the splitting pressure.
Position "II"
When both control levers are simultaneously placed in position "II", the pusher returns to its
home position and then goes back to position "0".
5
5.1
Operation
19
To Next Page
Loading...
