Posch SplitMaster 30 - Special Equipment; Radio Remote Control

Special equipment
Radio remote control
A radio-controlled machine is considerably easier to operate.
Radio control is used to wirelessly operate the rope winch.
Safety information
Familiarise yourself with the system before using radio control!
Only authorised persons who have received relevant training are permitted to operate the
machine with radio control!
You should always check that the emergency stop switch is working correctly before starting
to use the machine.
Take care when using radio control. Choose a safe location from where you can clearly see
the entire work area.
Never leave a transmitter switched on and unattended!
In the event of a fault, the radio control system must be shut down immediately.
▪ Switch off the radio transmitter using the emergency stop switch.
▪ Unplug the 7-pin plug from the tractor.
Transmitter
10
1
2
3
4
5
6
7
8
9
1 Button 1 6 Button 6
2 Button 2 7 Button 7
3 Button 3 8 Button 8
4 Button 4 9 Rotary safety button
5 Button 5 10 Emergency stop switch
The radio transmitter includes controls for actuating the various functions.
The emergency stop function must be deactivated before you can start using the transmitter.
▪ This is done by pulling the switch out to unlock it.
If the LED is flashing green, this indicates that the transmitter is ready. If the LED is
flashing red, this indicates that the battery is flat - charge the battery.
10
10.1
10.1.1
Special equipment
36