Install the drive on a non-flammable surface. Do not place flammable material nearby.
Otherwise fire could occur.
Disconnect the input power if the drive is damaged.
Otherwise, it could result in a secondary accident or fire.
After stopping the drive, it will remain hot for a couple of minutes. Touching hot parts may result in
skin burns.
Do not apply power to a damaged drive or to a drive with parts missing even if the installation is
complete. Otherwise, you may get an electric shock.
It is not permitted to weld the cabinet; this can damage the electronic sensitive equipment inside.
Do not allow lint, paper, wood chips, dust, metallic chips or other foreign matter into the drive.
Otherwise fire or accident could occur.
RECEPTION
The SD700FR are carefully tested and perfectly packed before delivering.
In the event of transport damage, please ensure that you notify the transport agency and POWER
ELECTRONICS: 902 40 20 70 (International +34 96 136 65 57) or your nearest agent, within 24hrs
from receipt of the goods.
UNPACKING
Make sure model and serial number of the variable speed drive are the same on the box, delivery
note and unit.
Each variable speed drive is delivered with Hardware and Software technical manuals.
RECYCLING
Packing of the equipments should be recycled. For this, it is necessary to separate different
materials included (plastic, paper, cardboard, wood ...) and deposit them on proper banks.
Waste products of electric and electronic devices should be selectively collected for your correct
recycling company.
EMC
The drive is intended to be used in industrial environment (Second Environment), it achieve
compliance with C3 category defined in IEC/EN 61800-3 standard following the installation
recommendation within this manual.
Select communication and control system according to the drive EMC environment. Otherwise,
systems could suffer from interferences due to a low EMS level.
To Next Page
Loading...
Need help?
General
